PRODUCTS

The Racer X Fabrication side window vents for the 1991-1995 Toyota MR2 were designed to replace the OEM vents that are faded, cracked or broken. The updated design matches the OEM MR2 side air intake vents for common design style and appearance. The vents are cut from 5052 Aluminum and anodized black to be similar to the OEM vent color. What's Included (2) MR2 side window vents (6) Stainless steel screws Compatibility 1991-1995 Toyota MR2 Installation Install Time: 15 to 30 mins Proposition 65...

The Racer X Fabrication MR2 Gen 4 downpipe flange takes the hard work out of having a custom downpipe made for your engine swap. The flange is CNC laser cut from 1018 cold rolled steel and CNC machined for smooth transitionally airflow into the divorced dump tube. Divorced downpipes have often been proven to provide better power output by preventing turbulent airflow at the outlet of the exhaust turbine housing. The dump tube should typically be routed 12 to 18” downstream from the outlet of...

The Racer X Fabrication Flex fuel kit for the 1991-1995 Toyota MR2 will allow you to use E85 with proper tuning from your EMS. The flex fuel kit mounts the sensor on the transmission roughly 1 foot from the OEM fuel filter. This allows for simple and short fuel hose routing to and from the sensor. The mounting bracket, sensor tie down, and rock guard are all CNC machined from 6061-T6 aluminum. Finally the components are anodized black for corrosion resistance and laser etched with the Racer X...

The Racer X Fabrication coolant temp sensor plug for the 1991-1995 Toyota MR2 is used to relocate the OEM MR2 gen 2 sensor to the back side of the coolant tree on Gen 4 swap engines. When used in combination with the Gen 4 relocation plug. This simple conversion eliminates having to extend your wire harness for the sensor location. What's Included (1) Coolant temp sensor plug (1) Coolant temp sensor plug relocation fitting Compatibility 1991-1995 Toyota MR2 Gen 4 Installation Install Time:...

The Racer X Fabrication flat bottom panels for the 91-95 Toyota MR2, are designed to be a direct replacement for the worn out, broken or busted OEM plastic panels. The OEM plastic panels are used to cover the fuel tank and the rear of the vehicle before the engine bay. The Racer X flat bottom panels are mounted from the front fascia to just before the engine bay. They are true flat bottom panels that use stand offs and additional mounting brackets to provide clearance between the body and...

The Racer X Fabrication mustang throttle body conversion for the 1991-1995 Toyota MR2 is a simple way to convert an 86-93 Mustang 5.0 throttle body to Toyota MR2 electronics. The mustang throttle body is a popular upgrade for many MR2 enthusiasts but leaves a little bit of a headache when attempting to use the OEM TPS, and ISC. The Racer X adapter plates for the Toyota TPS and ISC allow you to directly bolt these components onto a mustang throttle body. The finished assembly allows you to plug...

Why it works The Racer X Fabrication universal catch can was designed to reduce oil in the air stream when exiting the PCV and crankcase. The catch can / air oil separator works by intercepting the air / oil from the PCV or crankcase, and through a series of filters and baffles, keeps the oil in the catch can and allows the air to flow through. As the air and oil droplets enter the catch can they first pass through a micron stainless steel sintered filter to begin the separation process. Oil...