FR-S / BRZ / GT86 Front Lower Control Arms
The Racer X Fabrication front lower control arms for the 2013-2020 Scion FR-S / Subaru BRZ / Toyota GT86 were designed to reduce weight and increase rigidity. The OEM front lower control arms have been known to bend and flex under load. The Racer X control arms eliminate this by using light weight 4130 Chromoly tubing and chromoly rod ends. The control arms were designed in CAD from the OEM model to match and follow the small angle that is located at the rear of the control arm. The arms allow for on vehicle adjustment of camber and caster and are zinc plated black for corrosion resistance.
Installation Note
Racer X Fabrication is NOT responsible for damage to control arms from ball joints being installed incorrectly. Ball joint installation / removal REQUIRES specialized tooling, please make sure your installer / service center is properly equipped to handle this process.
*Not for use with extended ball joints.
What's Included
- (2) Front lower 4130 chromoly control arms
- (4) 1"-12 Bung nut adjuster
- (4) 1"-12 RH jam nut
- (4) 3/4"-16 LH rod end
- (4) 3/4"-16 LH jam nut
- (8) Aluminum bushings
Compatibility
- 2013-2020 Scion FR-S
- 2013-2020 Subaru BRZ
- 2013-2020 Toyota GT86
Installation
- Difficulty Level:
- Install Time: 1 to 2 hours
- Alignment recommended after installation.
- Installation Guide
- Proper Camber Adjustment
Proposition 65
WARNING: Cancer and Reproductive Harm
www.P65Warnings.ca.gov
Off Road Use Only
WARNING: Racer X Fabrication products are intended for off-road / competition use only and may never be used on a public road.